2 in 1 Car Dent Repair Tool Dent Puller Kit Slide Hammer Reverse Hammer Glue Tabs Suction Cups for Dent Removal

How to use this dent removal without repair kits
1. clean the dent with a clean, damp cloth;
2. Assemble the glue in the glue gun, pull the trigger to let the glue stick in the glue gun, connect the power source and preheat for 5 minutes;
3. Use a proper drawing seal. Large dent requires a large drawing seal. (Note: the larger the
Drawing seal is, the larger the drawing force is); 4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);
5. Quickly spot the drawing seal with hot melt glue in the center of the dent, press gently until the glue hardens and sticks (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be slightly shorter in winter);
6. Align the T-shaped repairer and press the drawing seal with hot melt glue, pull the sliding rod backwards to pull up the dent;
7. Check with a line board. If dent still exists, knock it lightly with a flattening hammer or pen;
8. Clean the repaired place with a clean, damp cloth.

Material: carbon steel Size: 50CM Standard: Car dent repair tool, dent repair device, hail pit repair equipment